Configure HTTP Artifact Credentials

Spinnaker supports reading HTTP files directly for artifacts.

If the files are hidden behind basic auth, you can configure an artifact account with the needed credentials to read your artifact. If not, no further configuration is needed, Spinnaker automatically adds a no-auth-http-account for this purpose.

You can configure more than one artifact account, each with separate credentials. Specify which account to use in the configuration for the stage that reads the data. If you have only one such account configured, the stage config for this is hidden, and the single account is automatically used.

Prerequisites

  1. Collect your basic auth $USERNAME and $PASSWORD

  2. Pick a $USERNAME_PASSWORD_FILE location on your disk

  3. Run:

    echo ${USERNAME}:${PASSWORD} > $USERNAME_PASSWORD_FILE
    

Edit your artifact settings

  1. Collect the $USERNAME_PASSWORD_FILE value returned from the prerequisites section above.

  2. Enable artifact support .

  3. Enable the HTTP artifact provider:

    hal config artifact http enable
    
  4. Add an artifact account:

    hal config artifact http account add my-http-account \
        --username-password-file $USERNAME_PASSWORD_FILE
    

There are more options described here if you need more control over your configuration.